Evaluation board with L298N is used as driver board
12V DC motor is controlled
The motor can be driven either in forward and reverse direction
The direction can be changed by changing the drive to the bridge circuit. This can be done by changing the PWM input from INA to INB and INB to INA
The Circuit is enabled by EN_AB pin
There is provision to connect two motors
+12V input is provided to the board
Microcontroller shall be used to control the Motor
The L298N board requires digital logic levels of 5V from Microcontroller as there is an on-board 5V supply which pulls up the digital signals. If needed driving from Microcontroller might need level translator
]]>
0 Comments